康普简介

    康普帮助设计、构建并管理世界各地有线和无线网络。作为通信基础设施的领先者,我们打造了始终在线的未来网络。40 多年来,由 20,000 多名员工,创新者和技术人员组成的全球团队始终致力于助力世界各地客户预测未来的趋势,突破现有的界限。

    康普于2004 年1 月中国苏州建厂,主要生产宽带同轴电缆、网络对绞线缆、铜及光纤连接器系列产品。

    电话:0512-8818 1000

    地址:江苏省苏州工业园区出口加工区二期启明路77号

    邮编: 215121

BSA antenna compI have spent over 20 years in the world of base station antenna design, and the changes are amazing. The first product I worked on was vertically-polarized with only a single input port, had fixed electrical downtilt and it covered seven percent bandwidth. Last year, CommScope released a 16-port antenna containing seven dual-polarized arrays, all featuring remote electrical tilt (RET) and functioning over bandwidths of up to 61 percent!

What’s driving these changes is the push for more capacity. In particular, the key for operators is capacity density defined as bits/Hz/sec/km2. Capacity in turn is driven via three different means:

  • Spectrum
  • Densification
  • Efficiency

Spectrum is about the hertz. The more megahertz available for data, the more data that can be sent. This has been driven by governments opening more and more spectrum each year for communications. To utilize more spectrum per antenna, today’s antennas contain more arrays with each array covering increasingly wide frequency bands.

CLICK TO TWEET:  Evolution of antennas on the road to 5G


Densification
is about square kilometers or miles and re-using spectrum by creating ever smaller cells in which every hertz available can be assigned to different users. Multi-beam antennas and small cell antennas used on metro sites are great ways to increase densification.

Efficiency focuses on the bits/sec. There are several ways to increase efficiency. One is to utilize MIMO (multiple input/multiple output) principles that enable a data stream to be broken into multiple pieces transmitted simultaneously over different paths between the base station antenna and the user. MIMO is why today’s antennas will contain four, or even eight or more arrays for each frequency band.

Efficiency also refers to the modulation scheme used, ranging from QPSK (Quadrature Phase Shift Keying) up to 256 QAM (Quadrature Amplitude Modulation), which greatly impacts the data speed. Accessing the higher QAM rates is only possible if the channel can achieve high SINR (Signal to Interference and Noise Ratio). This requires careful pattern sculpting and focus on critical antenna parameters like F/B (Front-to-Back) and SPR (Sector Power Ratio).

For more information about base station antennas, I invite you to check out chapter three in the updated “Understanding the RF Path” ebook. It gives a great general explanation of how base station antennas work and are designed, explains some of the key parameters, and talks about emerging trends.

About the Author

Martin Zimmerman

Marty Zimmerman is an engineering fellow and leads the antenna solutions team for base station antennas at CommScope, responsible for driving the development of next-generation antenna products based on collaborations with key customers. Other duties include managing the IP portfolio and providing technical guidance on M&A activities. Previously, Marty served as director of Engineering and senior principal antenna engineer for the same team. Prior to that, he worked as an antenna engineer for Sinclair Technologies and Analex, a NASA contractor. Marty holds 28 U.S. and numerous foreign patents in addition to having been published in several journals. He has a Bachelor of Science in electrical engineering from California Institute of Technology and a master’s degree and Ph.D. in electrical engineering from University of Illinois, Urbana-Champaign.

See all posts by this author

Comments

3 comments for "Evolution of antennas on the road to 5G"
Torstein Lunde Wednesday, June 05, 2019 7:49 AM

Hello,

We would be glad if you could send more information about your 5G basestation antennas for telephone operators.

Joe Depa Wednesday, June 05, 2019 12:27 PM

Hello Torstein, the base station antenna link is the hyperlink in the first paragraph of Martin's blog. I also included it here in the comment section.

https://www.commscope.com/Solutions/Base-station-antenna-systems/?utm_source=blog&utm_medium=socialmedia&utm_campaign=blogging

ERS Antenna Tuesday, October 01, 2019 9:06 AM

Thanks for sharing evolution of antennas, very helpful

Add Your Comment

Please submit your comment using the form below

 
(required)  
 

Powered By OneLink