Warning Icon

For other alternatives, please contact us for more information.

0 Alternative products available

3X-V65A-3XR

6-port tri-sector antenna, 6x 1710–2690 MHz, 65° HPBW, 3x RET.

Find a Partner
Specifications
Finish making your selections or clear them to view relevant specifications.
Features and Benefits
  • Three DualPol® antennas under one radome
  • Fully integrated flange mounting system for ease of installation
  • Ideal concealment solution for areas with special regulations regarding visual impact

General Specifications

Antenna Type Sector
Band Single band
Color Light Gray (RAL 7035)
Grounding Type RF connector inner conductor and body grounded to reflector and mounting bracket
Performance Note Outdoor usage | Wind loading figures are validated by wind tunnel measurements described in white paper WP-112534-EN
Radome Material Fiberglass, UV resistant
Radiator Material Low loss circuit board
RF Connector Interface 7-16 DIN Female
RF Connector Location Bottom
RF Connector Quantity, high band 6
RF Connector Quantity, mid band 0
RF Connector Quantity, low band 0
RF Connector Quantity, total 6

Remote Electrical Tilt (RET) Information

RET Interface 8-pin DIN Male
RET Interface, quantity 1 male
Input Voltage 10–30 Vdc
Internal RET High band (3)
Power Consumption, idle state, maximum 2 W
Power Consumption, normal conditions, maximum 13 W
Protocol 3GPP/AISG 2.0 (Single RET)

Dimensions

Length 1874 mm | 73.78 in
Net Weight, without mounting kit 19 kg | 41.888 lb
Outer Diameter 200 mm | 7.874 in

Electrical Specifications

Impedance 50 ohm
Operating Frequency Band 1710 – 2690 MHz
Polarization ±45°

Electrical Specifications

Frequency Band, MHz 1710–1880 1850–1990 1920–2180 2300–2500 2500–2690
Gain, dBi 17.3 17.4 18.3 18.6 18.9
Beamwidth, Horizontal, degrees 73 72 69 65 63
Beamwidth, Vertical, degrees 6.8 6.5 6.1 5.3 5.1
Beam Tilt, degrees 0–12 0–12 0–12 0–12 0–12
USLS (First Lobe), dB 15 15 15 17 17
Front-to-Back Ratio at 180°, dB 29 27 27 25 29
Isolation, Cross Polarization, dB 30 30 30 30 30
Isolation, Inter-band, dB 30 30 30 30 30
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150
Input Power per Port, maximum, watts 300 300 300 250 250

Mechanical Specifications

Wind Loading @ Velocity, frontal 211.0 N @ 150 km/h (47.4 lbf @ 150 km/h)
Wind Loading @ Velocity, maximum 211.0 N @ 150 km/h (47.4 lbf @ 150 km/h)
Wind Loading @ Velocity, rear 211.0 N @ 150 km/h (47.4 lbf @ 150 km/h)
Wind Speed, maximum 241 km/h (150 mph)

Packaging and Weights

Width, packed 356 mm | 14.016 in
Depth, packed 336 mm | 13.228 in
Length, packed 2055 mm | 80.906 in
Weight, gross 25.4 kg | 55.997 lb

Regulatory Compliance/Certifications

Agency Classification
CE Compliant with the relevant CE product directives
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
ROHS Compliant/Exempted
CHINA-ROHS Above maximum concentration value
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
UK-ROHS Compliant/Exempted

General Specifications

Antenna Type Sector
Band Single band
Color Light Gray (RAL 7035)
Grounding Type RF connector inner conductor and body grounded to reflector and mounting bracket
Performance Note Outdoor usage | Wind loading figures are validated by wind tunnel measurements described in white paper WP-112534-EN
Radome Material Fiberglass, UV resistant
Radiator Material Low loss circuit board
RF Connector Interface 7-16 DIN Female
RF Connector Location Bottom
RF Connector Quantity, high band 6
RF Connector Quantity, mid band 0
RF Connector Quantity, low band 0
RF Connector Quantity, total 6

Remote Electrical Tilt (RET) Information

RET Interface 8-pin DIN Male
RET Interface, quantity 1 male
Input Voltage 10–30 Vdc
Internal RET High band (3)
Power Consumption, idle state, maximum 2 W
Power Consumption, normal conditions, maximum 13 W
Protocol 3GPP/AISG 2.0 (Single RET)

Dimensions

Length 1874 mm | 73.78 in
Net Weight, without mounting kit 19 kg | 41.888 lb
Outer Diameter 200 mm | 7.874 in

Electrical Specifications

Impedance 50 ohm
Operating Frequency Band 1710 – 2690 MHz
Polarization ±45°

Electrical Specifications

Frequency Band, MHz 1710–1880 1850–1990 1920–2180 2300–2500 2500–2690
Gain, dBi 17.3 17.4 18.3 18.6 18.9
Beamwidth, Horizontal, degrees 73 72 69 65 63
Beamwidth, Vertical, degrees 6.8 6.5 6.1 5.3 5.1
Beam Tilt, degrees 0–12 0–12 0–12 0–12 0–12
USLS (First Lobe), dB 15 15 15 17 17
Front-to-Back Ratio at 180°, dB 29 27 27 25 29
Isolation, Cross Polarization, dB 30 30 30 30 30
Isolation, Inter-band, dB 30 30 30 30 30
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150
Input Power per Port, maximum, watts 300 300 300 250 250

Mechanical Specifications

Wind Loading @ Velocity, frontal 211.0 N @ 150 km/h (47.4 lbf @ 150 km/h)
Wind Loading @ Velocity, maximum 211.0 N @ 150 km/h (47.4 lbf @ 150 km/h)
Wind Loading @ Velocity, rear 211.0 N @ 150 km/h (47.4 lbf @ 150 km/h)
Wind Speed, maximum 241 km/h (150 mph)

Packaging and Weights

Width, packed 356 mm | 14.016 in
Depth, packed 336 mm | 13.228 in
Length, packed 2055 mm | 80.906 in
Weight, gross 25.4 kg | 55.997 lb

Regulatory Compliance/Certifications

Agency Classification
CE Compliant with the relevant CE product directives
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
ROHS Compliant/Exempted
CHINA-ROHS Above maximum concentration value
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
UK-ROHS Compliant/Exempted

Product Specification

Product Specification